3D printers beta · Anycubic
Owners keep the Kobra 3 for sharp multicolor prints and consistently good print quality, even as some accept a smaller build volume and rougher edges elsewhere.
Print quality draws clear praise: owners across many accounts describe consistently good results straight off the machine, and multicolor printing is called out just as often as a standout feature that works well for the price.
Customer support is a clear complaint. Owners describe slow responses, unclear ticket processes, and frustration getting issues resolved, especially when a machine arrives with a problem.
Pick up to three. You get a page with just those, side by side, on the subjects owners raised.
Once the excitement of a new printer wears off, owners keep coming back to two things: the multicolor output and the overall print quality, both of which hold up as genuine strengths rather than day-one novelty. Filament drying and general print reliability also earn steady praise from a solid number of owners, suggesting the machine settles into daily use without demanding constant babysitting for most people.
What owners had to adjust to varies. Build volume, build quality, and print speed are all divided: some owners are satisfied, others find them limiting or inconsistent, and neither side dominates. Bed leveling is more one-sided as a source of frustration, with more owners reporting trouble than success getting it dialed in.
Print reliability itself is praised by more owners than not, with several describing solid, repeatable results over time. But general machine reliability is a clear concern: more owners report problems than don't, and it's one of the more frequently raised issues in the accounts collected.
Owner accounts don't go deep into what specifically fails or how people work around it long-term. The comments describe frustration with support and bed leveling more than they describe mechanical failure points, so the long-term reliability picture here is thinner than the print quality picture, and that gap should be read as it is: not yet fully answered by the accounts on hand.
Counted from the owners who raised each subject, not from everyone. A subject is judged once at least 4 owners raise it.
2 more subjects came up from fewer than 4 owners each, which is not enough for a fair reading. To see how it stacks up, compare it with another machine.
The same owner, asked again at each point. Fills in as owners answer.
More in 3d printers: Creality Ender 3, Bambu Lab A1.
Public discussions we read and summarised in our own words. Nothing here was submitted to Still Kicks.
Counted from public accounts by people who said they own it, and summarised by Still Kicks in its own words. Not a manufacturer claim, a lab test or an estimate.
Nothing here asks for anything about you unless you write to us.