3D printers beta · Creality
Owners keep an Ender 3 running for years because print quality and reliability hold up once it's dialed in, even though they accept a small build volume and rough customer support along the way.
Owners describe print quality that holds up over long stretches, with some machines racing past tens of thousands of hours after being tinkered with and upgraded rather than replaced.
Owners consistently run into the small build plate, several saying it pushed them to add a second, larger printer or move on entirely once they needed bigger parts.
Pick up to three. You get a page with just those, side by side, on the subjects owners raised.
Once the initial setup is done, print quality and print speed stay a steady source of satisfaction, and owners doing multicolor or multi-material work say the results keep them printing regularly. Print reliability, once tuned, becomes routine background work rather than a daily fight, and several owners say the machine has become the one they trust for family projects and everyday parts.
What owners adjust to is the printer's open-frame design and modest bed size. More than one owner says the lack of an enclosure keeps them from safely printing ASA or nylon, and that eventually pushes them toward a second, enclosed machine for bigger or trickier jobs, while the Ender 3 stays in service for the everyday prints it already handles well.
Owners who stick with the Ender 3 for years describe upgrading parts over time (printheads, dual Z axis, control boards) rather than replacing the whole machine, and print reliability after that tuning is described positively by most who raised it. Filament drying comes up often too, with owners in humid climates managing it by adding drying solutions rather than treating it as a dealbreaker.
Long-term detail on customer support is thinner and mostly negative: owners who needed help from the manufacturer describe slow ticket responses and friction getting issues resolved, though a few say it worked out once they knew to include photos and video with a ticket. Build volume complaints are consistent and don't seem to change with time. Beyond upgrades and drying habits, owners don't say much about what eventually fails on these machines, so treat the long-run failure picture as thin.
Counted from the owners who raised each subject, not from everyone. A subject is judged once at least 4 owners raise it.
15 more subjects came up from fewer than 4 owners each, which is not enough for a fair reading. To see how it stacks up, compare it with another machine.
The same owner, asked again at each point. Fills in as owners answer.
More in 3d printers: Anycubic Kobra 3, Bambu Lab A1.
Public discussions we read and summarised in our own words. Nothing here was submitted to Still Kicks.
Counted from public accounts by people who said they own it, and summarised by Still Kicks in its own words. Not a manufacturer claim, a lab test or an estimate.
Nothing here asks for anything about you unless you write to us.